SMR test - Revision history

Sh at 08:23, 2 October 2014

2014-10-02T08:23:00Z

← Older revision		Revision as of 10:23, 2 October 2014
Line 20:		Line 20:
	Place the SMR on the start spot. Run the following command.		Place the SMR on the start spot. Run the following command.
	test@localhost:~/test$ ./mobotwaretest smrX		test@localhost:~/test$ ./mobotwaretest smrX
	The robot should say the guidemark numbers and should end up close to the starting point.		The test system will open 3 windows containing ulmsserver, ucamserver and mrc. As the robot moves around the course it should say the guidemark numbers and should end up close to the starting point.
			When the robot is finished close down the servers properly by type in "q" to the server.

Sh at 10:24, 1 October 2014

2014-10-01T10:24:02Z

← Older revision		Revision as of 12:24, 1 October 2014
Line 16:		Line 16:
	The advanced test uses a predefined course in the SMR-pit in the corner of room 027. The course is sketched below. It is necessary to put light-colored wooden planks along the base of the cabinet as the laser-scanner can't see the dark footing.		The advanced test uses a predefined course in the SMR-pit in the corner of room 027. The course is sketched below. It is necessary to put light-colored wooden planks along the base of the cabinet as the laser-scanner can't see the dark footing.

	[[File:test-course.png]]		[[File:test-course.png\|center]]

	Place the SMR on the start spot. Run the following command.		Place the SMR on the start spot. Run the following command.
	test@localhost:~/test$ ./mobotwaretest smrX		test@localhost:~/test$ ./mobotwaretest smrX
	The robot should say the guidemark numbers and should end up close to the starting point.		The robot should say the guidemark numbers and should end up close to the starting point.

Sh: Created page with "== SMR test procedures == Currently two tests are implemented for the SMR's. * A simple test checking that IR-sensors, linesensor and motorcontrollers are running and commu..."

2014-10-01T10:21:49Z

Created page with "== SMR test procedures == Currently two tests are implemented for the SMR's. * A simple test checking that IR-sensors, linesensor and motorcontrollers are running and commu..."

New page

== SMR test procedures ==

Currently two tests are implemented for the SMR's.

* A simple test checking that IR-sensors, linesensor and motorcontrollers are running and communicating with RHD and MRC.
* An advanced test that also includes guidemark's, and laser-based localisation.

Both tests are run by logging into the system as "test" and using the scripts found in the smr folder (/vhome/test/smr).

=== Simple Test ===
Place the SMR you want to test on teststand. Run the command from the smr folder.
test@localhost:~/test$ ./test smrX
Where smrX is the name of the SMR you are testing (fx. smr1).

=== Advanced Test ===
The advanced test uses a predefined course in the SMR-pit in the corner of room 027. The course is sketched below. It is necessary to put light-colored wooden planks along the base of the cabinet as the laser-scanner can't see the dark footing.

[[File:test-course.png]]

Place the SMR on the start spot. Run the following command.
test@localhost:~/test$ ./mobotwaretest smrX
The robot should say the guidemark numbers and should end up close to the starting point.