|
|
| (13 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| This is some suggestions for changed settings for Robobot.
| | Moved to [[regbot settings]] |
| | |
| == Robot configuration==
| |
| | |
| Metric setup
| |
| | |
| == Control issues ==
| |
| | |
| Some examples of control settings.
| |
| | |
| ===Edge control===
| |
| | |
| For higher speed in the range 0.7-0.9 m/s the following control settings could be used.
| |
| | |
| [[File:line_edge_control.png]] | |
| | |
| The control uses a Lag-controller to decrease the static gain by a factor 5 (a pole with a time constant of 1 sec and a zero with a time constant of 0.2 seconds). This means that the high frequency gain is Kp*0.2 = 0.06.
| |
| | |
| The gain is further scaled by the speed (from firmware version 604), so that the gain is reduced to half at 0.5m/s, but the filter times are maintained. This is probably a bad solution, as the response probably is more distance driven than time driven.
| |
| | |
| | |
| A test script to could be:
| |
| | |
| thread=1
| |
| vel=0.01, acc=5.0, log=20.0: time=0.2
| |
| vel=0.8, edger=0.7, white=1: dist=3.0, xw=20, log=0
| |
| label=3, event=3: xw<15
| |
| edger=-0.7, white=1: dist=1.5, xw=20, log=0
| |
| label=4, event=3: xw<15
| |
| edger=0.7, white=1: dist=1.5, xw=20, log=0
| |
| goto=3: count=1
| |
| vel=0.0: time=0.5
| |
| | |
| The mission follows right side of line,
| |
| * first in a left curve (1mØ) then
| |
| * a crossing line,
| |
| * wait for line to disappear,
| |
| * a right curve (1mØ),
| |
| * a crossing white line
| |
| * ...
| |
| | |
| The difference between a left and a right curve is the "edger=0.7" and "edger=-0.7", this makes the robot follow the offset by 0.7cm towards the center of the curve (more left in a left curve).
| |
