Drone control: Difference between revisions
From Rsewiki
No edit summary |
|||
| (8 intermediate revisions by the same user not shown) | |||
| Line 10: | Line 10: | ||
[[Drone control hardware]] | [[Drone control hardware]] | ||
[[File:schematic_rev0.png | | <!-- [[File:schematic_rev0.png | 150px]] --> | ||
== Drone software == | == Drone software == | ||
[[Drone firmware]] | [[Drone firmware]] | ||
== Magnetometer calibration == | |||
Calibration is used using a calibration version of firmware and a calibration app from Prop Shield manufacturer. | |||
[[Drone compass calibration]] | |||
== ESC calibration == | |||
The drone control uses ESC pulse width from 1 to 2 ms, and all ESCs should be calibrated to use this range. | |||
[[ESC calibration]] | |||
== Propeller - motor performance == | == Propeller - motor performance == | ||
[[Drone motor performance]] | [[Drone motor performance]] | ||
[[File:3508-700-14x5.5-11v.png | | [[File:3508-700-14x5.5-11v.png | 150px]] | ||
== Motor test app == | == Motor test app == | ||
[[Drone motor test app]] | [[Drone motor test app]] | ||
[[File:motortest_gui.png | | [[File:motortest_gui.png | 120px]] | ||
==Matlab simulation== | ==Matlab simulation== | ||
[[Drone MATLAB simulation]] | [[Drone MATLAB simulation]] | ||
[[File:drone_ctrl_sim_hex.png | | [[File:drone_ctrl_sim_hex.png | 120px]] | ||
Latest revision as of 10:49, 21 December 2020
Drone project
This project is intended to be a rather simple core drone stabilizer application based on Teensy and the prop shield.
Intended to be expanded with an outer control loop with a non-realtime sensor, e.g. GNSS, camera or laser scanner.
Hardware
Build on a hand-wired PCB as a prototype
Drone software
Magnetometer calibration
Calibration is used using a calibration version of firmware and a calibration app from Prop Shield manufacturer.
ESC calibration
The drone control uses ESC pulse width from 1 to 2 ms, and all ESCs should be calibrated to use this range.
