Regbot version 4: Difference between revisions
From Rsewiki
No edit summary |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
Back to [[Regbot]]. | |||
Back to [[Robobot]]. | Back to [[Robobot]]. | ||
| Line 22: | Line 24: | ||
Figure 3. REGBOT main board with annotated connectors. | Figure 3. REGBOT main board with annotated connectors. | ||
[[File:regbot_v4-in-place.jpg]] | |||
Figure 4. Version 4 board in place. | |||
Latest revision as of 18:00, 14 January 2021
Back to Regbot.
Back to Robobot.
Introduction
Version 4 has motor controller on-board and support for servos. This version is powered by a Teensy 3.5 processor (128 kB RAM and 512kB PROM at 120 MHz).
PCB: savner 12v output til ekstern PSU (raspberry, LED m.v.), udtag efter MOSFET switch. savner PWM+direction+enable output til extern motor controller.
Schematic and board
Figure 1. Schematic - click to get a readable version.
Figure 2. PCB layout
Figure 3. REGBOT main board with annotated connectors.
Figure 4. Version 4 board in place.
