Testpage: Difference between revisions
(Created page with "== Basic drone flight controller design and test == Projekttype Bachelorprojekt Startdato 01. feb 2021 Afleveringdato 25. jun 2021 Forklaring/indhold - dansk (Ikke angiv...") |
|||
| Line 1: | Line 1: | ||
== Basic drone flight controller design and test == | == Basic drone flight controller design and test == | ||
* Bachelorprojekt | |||
Startdato 01. feb 2021 | * Startdato 01. feb 2021 | ||
Afleveringdato 25. jun 2021 | * Afleveringdato 25. jun 2021 | ||
Forklaring/indhold - | ===Forklaring/indhold - engelsk=== | ||
The project is to design and test a basic flight controller for a quad or hexacopter drone. | |||
The flight controller is intended to be used in an extended control loop with additional onboard computer and sensors - like GNSS, laser scanner or cameras. | The flight controller is intended to be used in an extended control loop with additional onboard computer and sensors - like GNSS, laser scanner or cameras. | ||
The basic flight controller shall implement a roll, pitch, yaw and height control and allow an external entity to provide reference values for these, and be capable of implementing these with an update rate no longer than 10ms. | The basic flight controller shall implement a roll, pitch, yaw and height control and allow an external entity to provide reference values for these, and be capable of implementing these with an update rate no longer than 10ms. | ||
| Line 17: | Line 17: | ||
The basis is already existing hardware (a hexacopter) with almost functioning (Arduino Teensy) firmware, some user interface in Python and an initial Simulink model. | The basis is already existing hardware (a hexacopter) with almost functioning (Arduino Teensy) firmware, some user interface in Python and an initial Simulink model. | ||
Studerende | ===Studerende=== | ||
Projektopretter | 183723 ( Marcus Andreas Hansen, bachelor Elektrotek. ) | ||
===Projektopretter=== | |||
Jens Christian Andersen, jca@elektro.dtu.dk | |||
Revision as of 12:31, 4 June 2021
Basic drone flight controller design and test
- Bachelorprojekt
- Startdato 01. feb 2021
- Afleveringdato 25. jun 2021
Forklaring/indhold - engelsk
The project is to design and test a basic flight controller for a quad or hexacopter drone. The flight controller is intended to be used in an extended control loop with additional onboard computer and sensors - like GNSS, laser scanner or cameras. The basic flight controller shall implement a roll, pitch, yaw and height control and allow an external entity to provide reference values for these, and be capable of implementing these with an update rate no longer than 10ms.
The control should be based in Matlab Simulink model of the drone, and correspondence between this and the real drone should be documented.
Stability against load change - e.g. a (heavy) sensor above or below the propeller plane - should be documented.
The basis is already existing hardware (a hexacopter) with almost functioning (Arduino Teensy) firmware, some user interface in Python and an initial Simulink model.
Studerende
183723 ( Marcus Andreas Hansen, bachelor Elektrotek. )
Projektopretter
Jens Christian Andersen, jca@elektro.dtu.dk
