Scorpi: Difference between revisions
From Rsewiki
No edit summary |
|||
Line 13: | Line 13: | ||
Install packages: | Install packages: | ||
libreadline-dev | |||
libopencv-dev | |||
libgpiod-dev | |||
gpiod | |||
cmake | |||
subversion | |||
aptitude | |||
ntp | |||
ntpdate | |||
nmap | |||
lsof | |||
sudo apt install libreadline-dev libopencv-dev libgpiod-dev gpiod cmake subversion aptitude nmap lsof | |||
=== YDLidar (S4B) === | === YDLidar (S4B) === |
Revision as of 10:59, 31 March 2024
Overview
Development nodes
Raspberry pi
Raspberry pi 5 installation
- enable serial IO hardware (pin 15,16)
Install packages:
libreadline-dev libopencv-dev libgpiod-dev gpiod cmake subversion aptitude ntp ntpdate nmap lsof sudo apt install libreadline-dev libopencv-dev libgpiod-dev gpiod cmake subversion aptitude nmap lsof
YDLidar (S4B)
Forbindelse connected like
YDLIDAR cable color Raspberry 1 Vcc (5V) black 4 (5V) 2 Tx red 10 (GPIO 16) (RxD) 3 Rx white 8 (GPIO 15)(TxD) 4 Gnd Yellow 6 (Ground) 5 M_SCP Orange 18 (GPIO 5) 6 Dev_enable Green 16 (GPIO 4) 7 M_enable Blue 12 (GPIO 1) 8 NC Purple 14 (ground
Software YDLidar-SDK
From Git repository
$ mkdir -p git $ cd git $ git clone https://github.com/YDLIDAR/YDLidar-SDK.git $ cd YDLidar-SDK $ mkdir build $ cd build $ cmake .. $ make -j4