Regbot: Difference between revisions
No edit summary |
|||
| Line 17: | Line 17: | ||
==Development pages== | ==Development pages== | ||
This part is for design issus, and not needed for normal user. | |||
It consist of an 72MHz 32bit ARM processor on a teensy 3.1 board, controlling a pololu motor controller and 2 small pololu motors with magnetic encoder. A further sensor is sparkfun LSM9050 IMU. Supplied by 12V 3A from 220V on a thin wire. The processor, IMU and wheel-encoders can be supplied from USB. | It consist of an 72MHz 32bit ARM processor on a teensy 3.1 board, controlling a pololu motor controller and 2 small pololu motors with magnetic encoder. A further sensor is sparkfun LSM9050 IMU. Supplied by 12V 3A from 220V on a thin wire. The processor, IMU and wheel-encoders can be supplied from USB. | ||
Revision as of 08:28, 11 January 2015
Small robot intended for control-1 exercises.
User interface
The user interface can configure and run the robot, as wel as inspecting almost all values on the robot.
Install client in Windows
Get the regbot.exe from the course homepage, place it in a directory, this directory will be default for configuration file and result files from the robot.
A driver must be installed to get in contact with the robot - see installation in windows
The driver willcreate a com-port when connected - most likely com3. When the robot is disconnected by unplugging the cable, then the client needs to be restarted if it was connected when the cablewas unplugged.
for more advanced installation see installation in windows
Development pages
This part is for design issus, and not needed for normal user.
It consist of an 72MHz 32bit ARM processor on a teensy 3.1 board, controlling a pololu motor controller and 2 small pololu motors with magnetic encoder. A further sensor is sparkfun LSM9050 IMU. Supplied by 12V 3A from 220V on a thin wire. The processor, IMU and wheel-encoders can be supplied from USB.
- Software installation and tool-charin
- Design calculations
- installation in windows
