REGBOT version 3: Difference between revisions
From Rsewiki
| Line 12: | Line 12: | ||
REGBOT 36 LIV has new board (and new battery/charger mount (3D print) | REGBOT 36 LIV has new board (and new battery/charger mount (3D print) | ||
* Line sensor low power pin (Teensy pin 25) now working. Pin 25 set to output in main.cpp (line 125), and pulsed in main.cpp (line 425 and 466). | * Line sensor low power pin (Teensy pin 25) now working. Pin 25 set to output in main.cpp (line 125), and pulsed in main.cpp (line 425 and 466). Line estimate seems OK (after calibration) - line sensor calibration missing in regbot.ini. | ||
* Space for charger is too small - hits line sensor 6-pin plug on main-board and hits line sensor 90 deg 10-pin plug in other end. Should lower buttom plates by e.g. 4mm. | * Space for charger is too small - hits line sensor 6-pin plug on main-board and hits line sensor 90 deg 10-pin plug in other end. Should lower buttom plates by e.g. 4mm. | ||
| Line 18: | Line 18: | ||
* Battery power (XT60) should have small plug on main PCB, so that XT60 plug can be fixed to battery/charger mount. | * Battery power (XT60) should have small plug on main PCB, so that XT60 plug can be fixed to battery/charger mount. | ||
* IR sensor power control is OK | * IR sensor power control is OK. IR sensor calibration missing in regbot.ini. | ||
* Power off by "halt" and by too low battery voltage is OK, back on by "power" button in both cases OK. Power off (by halt), no USB, then power on by power button is OK. | * Power off by "halt" and by too low battery voltage is OK, back on by "power" button in both cases OK. Power off (by halt), no USB, then power on by power button is OK. | ||
* wifi (on board part) is working (client is not) - tested with putty (not on SSID=device) | * wifi (on board part) is working (client is not) - tested with putty (not on SSID=device) | ||
Revision as of 12:08, 28 August 2016
Aim
- maintain frame,
- Avoid too many satellite PCB's,
- more powerfull 5V,
- fix PCB errors on version 2,
- new servo interface plug
Status and observations
REGBOT 36 LIV has new board (and new battery/charger mount (3D print)
- Line sensor low power pin (Teensy pin 25) now working. Pin 25 set to output in main.cpp (line 125), and pulsed in main.cpp (line 425 and 466). Line estimate seems OK (after calibration) - line sensor calibration missing in regbot.ini.
- Space for charger is too small - hits line sensor 6-pin plug on main-board and hits line sensor 90 deg 10-pin plug in other end. Should lower buttom plates by e.g. 4mm.
- Battery power (XT60) should have small plug on main PCB, so that XT60 plug can be fixed to battery/charger mount.
- IR sensor power control is OK. IR sensor calibration missing in regbot.ini.
- Power off by "halt" and by too low battery voltage is OK, back on by "power" button in both cases OK. Power off (by halt), no USB, then power on by power button is OK.
- wifi (on board part) is working (client is not) - tested with putty (not on SSID=device)
