Drone motor test app: Difference between revisions
From Rsewiki
No edit summary |
No edit summary |
||
Line 11: | Line 11: | ||
Software is part of mobotware using the name 'drone_ctrl'. | Software is part of mobotware using the name 'drone_ctrl'. | ||
== | == Drone test app== | ||
A motor test GUI is available (in the motortest_gui directory) - it will talk to the | A motor test GUI is available (in the motortest_gui directory) - it will talk to the drone_ctrl firmware - some functions will work without the prop-shield. | ||
[[File:motortest_gui.png | 600px]] | [[File:motortest_gui.png | 600px]] | ||
Line 20: | Line 20: | ||
The hardware configuration and pin-out are described in the hardware section above. | The hardware configuration and pin-out are described in the hardware section above. | ||
Revision as of 15:20, 17 November 2020
back to Drone control
Configuration and test app
The app is intended to configure, measure and test the drone (inner) flight-controller.
It is written with Qt5 and python
It runs with python 2.7++ and version 3.
Software is part of mobotware using the name 'drone_ctrl'.
Drone test app
A motor test GUI is available (in the motortest_gui directory) - it will talk to the drone_ctrl firmware - some functions will work without the prop-shield.
Motor test GUI. There is the possibility to log time performance (in the log tab), to test run an ESC (or up to 6 ESCs) in the data tab.
The hardware configuration and pin-out are described in the hardware section above.