ESC calibration: Difference between revisions
No edit summary |
|||
Line 21: | Line 21: | ||
* Disconnect battery | * Disconnect battery | ||
With the controller connected to the PC, set manual motor value to 1000, as shown below: | === Set to max 'stick' === | ||
With the controller connected to the PC and connected to the GUI, set the manual motor value to 1000, as shown below: | |||
[[File:esc-calibration-max-stick-gui.png | 600px]] | [[File:esc-calibration-max-stick-gui.png | 600px]] | ||
Set to | Click all mounted motors to manual, Set manual value to 1000 for all motors and press 'Apply manual values'. | ||
=== Connect battery === | |||
Connect the battery and wait for the motors to beep. | |||
=== Set to minimum 'stick' === | |||
Set all values to 0 as shown | |||
[[File:esc-calibration-min-stick-gui.png | 600px]] | |||
Set values to 0 for all motors and press 'Apply manual values'. | |||
The motors reply with another beep, and we are finished. |
Revision as of 13:57, 2 December 2020
Back to Drone control
ESC calibration
The ESC used her is
- Hobbywing 40A 3-6 Lipo cell controller.
Manual is here: https://cdn.shopify.com/s/files/1/0109/9702/files/User_s_Manual_Xrotor-en.pdf?7945784144032874852
The calibration instructions are as in this figure, but use the GUI to set the ranges right.
Basic calibration instructions, but replace stick with GUI based calibration.
Gui based ESC calibration
NB!
- Remove propellers.
- Disconnect battery
Set to max 'stick'
With the controller connected to the PC and connected to the GUI, set the manual motor value to 1000, as shown below:
Click all mounted motors to manual, Set manual value to 1000 for all motors and press 'Apply manual values'.
Connect battery
Connect the battery and wait for the motors to beep.
Set to minimum 'stick'
Set all values to 0 as shown
Set values to 0 for all motors and press 'Apply manual values'.
The motors reply with another beep, and we are finished.