Optitrack on Raspberry Pi
Using optitrack and thin NatNet client
Install
Get client from https://github.com/b4be1/packet-client-linux e.g. from the raspberry:
git clone https://github.com/b4be1/packet-client-linux.git cd packet-client-linux mkdir build cd build cmake .. make
Raspberry setup
On the raspberry pi set the wireless network to access the dedicated optitrack network
Modify the /etc/wpa_supplicant/wpa_supplicant.conf by adding the network groups, maybe the 5Ghz SSID should have highest priority.
ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev ctrl_interface_group=0 update_config=1 country=DK network={ ssid="asta_optitrack" psk="asta2020" priority=1 } network={ ssid="asta_optitrack_5G" psk="asta2020" priority=2 }
Restart the network by reboot or just restart the network
sudo /etc/init.d/networking restart
Optitrack setup
In EDIT mode
In 'View' and 'Data streaming pane' select local interface to the IP address of the server and deselect other streaming services (VRPN and Trackd)
Then go live, and assuming there is rigid bodys, streaming should commence
modify source
The NatNet version should be changed - it is hard-coded in source file.
cd ~/packet-client-linux nano PacketClient.cpp
A bit down change the NatNetVersion to 3.1 (to fit Motive version 2.2)
// Versioning int NatNetVersion[4] = {3, 1, 0, 0}; int ServerVersion[4] = {0, 0, 0, 0};
Compile the client
Compile
cd ~/packet-client-linux/build make
Run the client
cd ~/packet-client-linux/build ./PacketClient DESKTOP-OVLVRUD.local 192.168.1.136
where DESKTOP-OVLVRUD is the hostname of the optitrack server (in ASTA) and 192.168.1.136 is the IP of the raspberry pi in this case.