Raspberry base install: Difference between revisions
From Rsewiki
No edit summary |
No edit summary |
||
| (One intermediate revision by the same user not shown) | |||
| Line 11: | Line 11: | ||
rpi-imager | rpi-imager | ||
First configure settings: click the gear icon, and set: | '''First''' configure settings: click the gear icon, and set: | ||
* enable ssh, hostname, English language, Danish keyboard, possibly SSID, time zone, username (local) and password (remember to spell the password correctly). | * enable ssh, hostname, English language, Danish keyboard, possibly SSID, time zone, username (local) and password (remember to spell the password correctly). | ||
| Line 52: | Line 52: | ||
In this case, the IP4 (inet) is 10.197.217.175. | In this case, the IP4 (inet) is 10.197.217.175. | ||
If you don't get an IP, the wifi may not be set correctly (see the | If you don't get an IP, the wifi may not be set correctly (see the [[Network setup]]). | ||
Latest revision as of 10:38, 22 October 2023
Back to robobot B
Installation from blank SD-flash
Install Raspberry
Use Raspberry pi imager (download from https://www.raspberrypi.com/software/)
rpi-imager
First configure settings: click the gear icon, and set:
- enable ssh, hostname, English language, Danish keyboard, possibly SSID, time zone, username (local) and password (remember to spell the password correctly).
then
Select operating system 'Raspberry Pi OS lite' and storage, an empty SD-flash of at least 16GB, then write.
When finished, mount the SD into the Raspberry
Start Raspberry
If everything is configured as above, then you just need to figure out the IP. On a Linux computer, you can find the Raspberry IP address using (if on the same local net):
sudo apt install net-tools nmap nmap -sP 192.168.2.0/24
else
You need a screen and keyboard.
Log on to the Raspberry Pi
$ ifconfig
eth0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
...
lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
...
wlan0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 10.197.217.175 netmask 255.255.252.0 broadcast 10.197.219.255
inet6 fe80::f620:b431:69cc:44f4 prefixlen 64 scopeid 0x20<link>
ether dc:a6:32:f4:0e:a4 txqueuelen 1000 (Ethernet)
RX packets 486 bytes 41505 (40.5 KiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 421 bytes 43403 (42.3 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
In this case, the IP4 (inet) is 10.197.217.175.
If you don't get an IP, the wifi may not be set correctly (see the Network setup).
