Regbot: Difference between revisions

From Rsewiki
No edit summary
No edit summary
 
(193 intermediate revisions by 2 users not shown)
Line 1: Line 1:
Small robot intended for control-1 exercises.


==Version==
REGBOT is a small robot designed for exercises for our linear control 1 course (PID control) ([http://www.dtu.dk/english/Service/Phonebook/Person?id=14453 author]).


*Robot software (regbot.hex): 95
[[file:foto_of_Alba_40.png | 250px]]


*Client software for windows (regbot.exe): 95
Figur 1. Version 2 of Regbot.


(as of June, 2015)
== Overview ==


==Install client in Windows==
This section is intended for users.


Get the regbot.exe from the course homepage, place it in a directory, this directory will be default for configuration file and result files from the robot.
[[Getting started]] with REGBOT GUI.


A driver must be installed to get in contact with the robot - see [[installation in windows]]
[[User interface]], how to configure the robot using the Regbot client.


The driver will create a com-port when connected - most likely com3 or any higher number.
[[Control]] overview gives some information on control possibilities.
When the robot is disconnected by unplugging the cable, then the client needs to be restarted if it was connected when the cable was unplugged (no connection detect in windows).


* [[Software installation]] and tool-chain - Linux
[[Mission]], how to write a mission.
* [[installation in windows]] some of the tool-chain
* [[Schematic]]


repository for software - client and robot
[[Regbot calibration]] for better performance.


* client: svn://repos.gbar.dtu.dk/jcan/regbot/qtgui
[[Regbot maintenance]] for longer life.
* robot:  svn://repos.gbar.dtu.dk/jcan/regbot/regbot


==User interface==
[[Regbot GUI]] installation.


The user interface can configure and run the robot, as wel as inspecting almost all values on the robot. Written in python using Qt GUI library.
[[Regbot hardware board]].


[[File:Gui_rev0.png]]
== Install notes ==


for more advanced installation see [[installation in windows]]
This section is primarily installation notes and more detailed descriptions not usually needed by the end-user.


==Design overview==
[[Regbot command interface]] - command list.


[[File:Blockdiagram.png]]
[[Software installation]] on REGBOT (Arduino) and tool-chain - Linux


* [[Design calculations]]
[[Regbot old stuff]]

Latest revision as of 14:17, 17 October 2024

REGBOT is a small robot designed for exercises for our linear control 1 course (PID control) (author).

Figur 1. Version 2 of Regbot.

Overview

This section is intended for users.

Getting started with REGBOT GUI.

User interface, how to configure the robot using the Regbot client.

Control overview gives some information on control possibilities.

Mission, how to write a mission.

Regbot calibration for better performance.

Regbot maintenance for longer life.

Regbot GUI installation.

Regbot hardware board.

Install notes

This section is primarily installation notes and more detailed descriptions not usually needed by the end-user.

Regbot command interface - command list.

Software installation on REGBOT (Arduino) and tool-chain - Linux

Regbot old stuff