Robobot hardware: Difference between revisions
From Rsewiki
| Line 4: | Line 4: | ||
[[File:robobot-design-2024.png | 400px]] | [[File:robobot-design-2024.png | 400px]] | ||
==Mounting holes== | |||
The hardware is 3D-printed plastic (except for the electronics and screws) | The hardware is 3D-printed plastic (except for the electronics and screws) | ||
All 3D printed parts have holes for mounting additional parts. These holes have: | All 3D printed parts have holes for mounting additional parts. These holes have: | ||
* Individual hole distance of 1cm | * Individual hole distance of 1cm. | ||
* Hole diameter of 2.5mm, intended for 3mm plastic screws. | * Hole diameter of 2.5mm, intended for 3mm plastic screws. | ||
* Plastic thickness is 6mm in most cases. | * Plastic thickness is 6mm in most cases. | ||
==Plastic screws== | |||
Mounting items on the 3D printed plastic should use plastic screws. | |||
Plastic screws: | |||
* Cut into the plastic with a sharp thread. | |||
* Gets locked in the plastic and will not shake loose. | |||
Revision as of 11:44, 22 October 2023
Back to Robobot B
Hardware
Mounting holes
The hardware is 3D-printed plastic (except for the electronics and screws)
All 3D printed parts have holes for mounting additional parts. These holes have:
- Individual hole distance of 1cm.
- Hole diameter of 2.5mm, intended for 3mm plastic screws.
- Plastic thickness is 6mm in most cases.
Plastic screws
Mounting items on the 3D printed plastic should use plastic screws.
Plastic screws:
- Cut into the plastic with a sharp thread.
- Gets locked in the plastic and will not shake loose.
