Robobot hardware

From Rsewiki
Revision as of 11:44, 22 October 2023 by Jca (talk | contribs) (→‎Hardware)

Back to Robobot B

Hardware

Mounting holes

The hardware is 3D-printed plastic (except for the electronics and screws)

All 3D printed parts have holes for mounting additional parts. These holes have:

  • Individual hole distance of 1cm.
  • Hole diameter of 2.5mm, intended for 3mm plastic screws.
  • Plastic thickness is 6mm in most cases.

Plastic screws

Mounting items on the 3D printed plastic should use plastic screws.

Plastic screws:

  • Cut into the plastic with a sharp thread.
  • Gets locked in the plastic and will not shake loose.