Robobot hardware

From Rsewiki
Revision as of 11:51, 22 October 2023 by Jca (talk | contribs)

Back to Robobot B

Hardware

Mounting holes

The hardware is 3D-printed plastic (except for the electronics and screws)

All 3D printed parts have holes for mounting additional parts. These holes have:

  • Individual hole distance of 1cm.
  • Hole diameter of 2.5mm, intended for 3mm plastic screws.
  • Plastic thickness is 6mm in most cases.

Plastic screws (PT-screws)

Mounting items on the 3D printed plastic should use plastic screws.

Plastic screws:

  • Cut into the plastic with a sharp thread.
  • Gets locked in the plastic and will not shake loose.

We have a selection of screws:

  • Pan-head 3mm diameter and length:
    • 6mm, 10, 14mm, 18mm
  • Countersunk 3mm
    • 10mm, 14mm