Regbot first setup

Back to Regbot

Initial settings

After a "factory reset", a few settings are needed.

Assuming that the robot is connected using the USB cable. The Regbot GUI is running and connected to the robot. I.e. robot time and name is updated.

ID

The ID must match the robot. If ID is zero, then no configuration can be saved.

If ID is wrong, go to the "Robot" tab.

Press Edit, change the ID, press "Apply" and after that "Save to flash".

The other settings should be:

• Hardware: 9
• Wheel base: 0.15 (m) - measure is better
• Gear: 9.68
• Pulses per rev: 48
• Wheel radius: 0.03 (m) - measure is better.
• Sample time: 0.001 (sec)

IMU

To measure the robot tilt, an IMU is used, this need calibration.

Go to the IMU tab.

The Gyro should show some noise, if not, then you may have an old IMU (MPU9150) and this will not work. Ask for a replacement (they are ordered 12 feb 2025, but not delivered, expected to arrive 12 mar 2025 - from China, sorry /jca)

Gyro

• Press the "calibrate" while the robot is standing still.
• Press "save to flash"

Balance point

The IMU is almost upside down, so the board y-angle must be set between 160 and 180 degrees.

• Press "Edit"
• Keep the robot at the balance point
• The tilt angle should now be zero (within +/- 1 degree); if not, adjust the IMU board y-angle. If the tilt is too high, then reduce the angle.
• Press apply
• Press "save to flash"

Control

Switch to the "control" tab.

All controllers are disabled as default. The first use is without a controller, which is needed to make a mission.

• Click on "Velocity"
• Enable controller (checkmark)
• Set Kp to 0 (zero)
• Enable "Feed forward"
• Set Kf to 1.
• Set output limit to 8 (V)
• Press "OK" to save
• Press "save to flash"

Test

• Make sure the power switch is on (else it is running on USB power)

Go to the "Mission tab"

In the "Mission lines" field enter something like:

log=1:time=0.01
vel=3: dist=0.5
vel=0: time=1

• Press "save to robot" and ensure that it replies "No errors found".
• Press "save to flash"

Lift the robot and

• Press "start" (or the green start button on the robot)

It should now move forward 0.5m.

Test balance

This requires that the IMU is working and available!

With the robot on the floor (no cable)

• Supporting it in a close-to-balance position (and be prepared to catch if it fails to balance)
• Press the green start button twice.

It should now keep its balance for 5 seconds.