Robobot circuits: Difference between revisions
From Rsewiki
(Created page with "Back to Robobot_B == Digital IO == File:digital_IO-circuit.png Figure 1. The circuit diagram should ensure that each IO pin can function as both input and output. ...") |
No edit summary |
||
| Line 14: | Line 14: | ||
Figure 2. | Figure 2. | ||
The PCB layout for the digital IO circuit. | The PCB layout for the digital IO circuit. | ||
== Regbot == | |||
[[File:regbot_6.3.png | 800px]] | |||
Figure 3. The Regbot circuit. | |||
[[File:regbot_6.3_PCB.png | 800px]] | |||
Revision as of 09:12, 27 December 2023
Back to Robobot_B
Digital IO
Figure 1. The circuit diagram should ensure that each IO pin can function as both input and output. If input, then the pin has active pull down, i.e. for input to change, it must be pulled high, to at least 3.3V, but 5 or 12V will work too. If output, then a transistor is active when output is high, and can draw at least 1A from the 12V supply. The 5V and 3.3V can supply no more than 100mA.
Figure 2. The PCB layout for the digital IO circuit.
Regbot
Figure 3. The Regbot circuit.
